Instructions / Assembly

7 HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly (continued)

ASSEMBLING THE BASE TO THE CHAIR SEAT

□ Place the Chair Seat (A) on a non-abrasive flat surface. Align the holes on the support bar on the underside of

the chair seat with the holes on the Spring Plates which are pre-attached to the chair base. Insert the Hex Bolts

(AA) through the Washers (EE), C Clamp Plates (DD), Support Bar, Spring Plates and the C Clamp Plates (DD)

as showed in the diagram. Secure the Hex Bolts (AA) with Nuts (GG). The support bar and spring plate should

be sandwiched in between the C Clamp Plates (DD). See figure.

□ Once all the Nuts (GG) and Hex Bolts (AA) are in place, securely tighten all the

Hex Bolts (AA) and Nuts (GG);

including the ones at the front part of the rocker mechanism with the Hex Wrench (LL).

□ Cover all the Nuts (GG) with Nuts Caps (HH) and all the Hex Bolts (AA) with Hex Bolts Caps (II).

□ Test the rocker gently. If the rocker does not rock properly, double check the assembly procedure and make

sure it is assembled correctly.

CAUTION: Improper assembly may result in serious

personal injury.

U Support