SDS

Page 4 of 9
Issuing date: August 19, 2016
7. Handling and storage
The regulations relating to storage remises apply to workshop where the product is handled :
Handling: (for contact with leakage from rupture)
Do not breathe dust.
Wash hands thoroughly after handling.
Do not eat, drink or smoke when using this product.
Wear protective gloves/protective clothing/eye protection/face protection.
Storage:
Requirements to be met by storerooms and receptacles:
NOTE: STOW AWAY FROM SOURCES OF HEAT.
Avoid mechanical or electrical abuse. Storage preferably in cool, dry and ventilated area,which is subject to little temperature
change. Storage at high temperatures should beavoided. Do not place the batterynear heating equipment, nor expose to direct
sunlight forlong periods.
Packing material: Plastic.
Information about storage in one common storage facility: The storeroom should be equipped with proper facilities for
accidental fire.
Further information about storage condition: None.
8. Exposure controls/personal protection
Control parameters: (for contact with leakage from rupture)
Ingredients OSHA PEL-TWA ACGIH TLV-TWA
Manganese dioxide (CAS: 1313-13-9)
5 mg/m
3
(Ceiling limit) 0.1mg/m
3
Copper (CAS: 7440-50-8)
1 mg/m
3
(Dusts and mists) 1 mg/m
3
(Dusts and mists)
Graphite (CAS: 7782-42-5) 15 mg/m
3
(Total dust)
5 mg/m
3
(Respirable fraction)
2mg/m
3
Engineering Control(for contact with leakage from rupture):
Use this product only in closed systems fully or with local exhaust ventilation.
Install washer eyes and safety showers near to the handling and storage area.
Shows the location of these facilities, with a clear and prominent warning board.
Personal Protective Equipment (for workers):
Protection of Hands:
Not necessary under conditions of normal use.
Recommend wearing protective gloves for industrial hygienic purpose (for contact with leakage from rupture).
Protection of Eyes:
Not necessary under conditions of normal use.