Use and Care Manual

11
ASSEMBLY INSTRUCTIONS
10
Standard 20 lb. tank
10. Connect hose and regulator to cylinder.
The propane gas and cylinder are sold separately.
Use a standard 20 lb. propane cylinder only.
(approximately 12.2 in./31cm. in diameter and 17.9 in.
/45.5cm high).
Use this heater only with a propane vapor withdrawal
supply system. See chapter 5 of the standard for
storage and handling of liquefied petroleum gas,
ANS/NFPA 58. Your local library or fire department
should have this book.
Storage of an appliance indoors is permissible only if
the cylinder is disconnected and removed from the
appliance. A cylinder must be stored outdoors in a
well-ventilated area out of the reach of children. A
disconnected cylinder must have dust caps tightly
installed and must not be stored in a building, garage or
any other enclosed area. The maximum inlet gas supply pressure: 250 psi /1750 kPa.
The minimum inlet gas supply pressure: 25 psi /175kPa. Manifold pressure with regulator provided:
11 inch W.C/2.74 kPa.The pressure regulator and hose assembly supplied with the appliance must
be used. when an appliance is for connection to a fixed piping system, the installation must conform
with local codes, or in the absence of local codes with the National Fuel Gas Code,
ANSI Z223.1 • NFPA 54; National Fuel Gas Code; Natural Gas and Propane Installation Code,
CSA B149.1; or Propane Storage and Handling Code, CSA B149.2, as applicable;
Properly locating the gas hose including locating the hose out of pathways where people may trip over
it or in areas where the hose may be subject to accidental damage.
A dented, rusted or damaged propane cylinder may be hazardous and should be checked by your
cylinder supplier. Never use a propane cylinder with a damaged valve connection.
The propane cylinder must be constructed and marked in accordance with the specifications for
LP gas cylinders of the U.S. Department of Transportation (DOT) or the standard for cylinders,
spheres and tubes for transportation of dangerous goods and commission, CAN/CSA-B339.
The cylinder must have a listed overfilling prevention device.
The cylinder must have a connection device compatible with the connection for the appliance.
12.2 in./31cm
17.9 in./45.5cm