Use and Care Manual

ASSEMBLY INSTRUCTIONS

Do not store a spare LP-gas cylinder under or near this appliance;

Never fill the cylinder beyond 80 percent full;

Place the dust cap on the cylinder valve outlet whenever the cylinder is not

in use. Only install the type of dust cap on the cylinder valve that is provided with

the cylinder valve. Other type of caps or plugs may result in leakage of propane.

ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE INTENDED

FOR RESIDENTIAL USE ONLY.

Do not sit or stand on this table .

Keep children away during assembly, This item contains small parts which can be

swallowed by children.

Do not use indoors and inside any enclosure.

Retain the assembly instruction for future reference.

Installer – Please leave these instruction with the owner.

Please quote following FQC NO. when contacting service center.

The cylinder used must include a collar to protect the

cylinder valve.

Never connect an unregulated propane cylinder to the

heater. Attach regulator to cylinder. Complete attachment.

Fasten cylinder with butterfly bolt, install cylinder.

The appliance must be isolated from the gas supply

piping system by closing its individual manual shutoff

valve during any pressure testing of the gas supply

piping system at test pressures equal to or less than

1/2psi (3.5kPa).

Other cylinders may be acceptable for use with the

appliance provided they are compatible with the appliance

retention means.

The knob on the LP tank must be closed. Make sure that

the knob is turned clockwise to a full stop. The

cylinder supply system must be arranged for vapor

withdrawal. Check that the control knob on the control

unit is turned off. Hold the regulator in one hand and

insert the nipple into the valve outlet. Be sure the nipple

is centered in the valve outlet. The coupling nut connects

to the large outside threads on the valve outlet.

Hand-tighten the coupling nut clockwise until it comes

to a full stop. Firmly tighten by hand only.

To Disconnect: Fully close the tank valve by turning

clockwise. Turn the coupling nut counterclockwise

until the regulator assembly detaches.