Use and Care Manual

Operating (continued)
WARNING
LIGHTING INSTRUCTIONS
FOR YOUR SAFETY:
Keep face and body away from burner
area when lighting.
Ensure burner controls are in the off
position. Slowly turn on the gas supply
valve.
WARNING
FOR YOUR SAFETY:
The propane cylinder is equipped with
an excess flow device. Unless burners
are turned off prior to turning the
cylinder on, only small flames and low
heat will be achievable.
WARNING
FOR YOUR SAFETY:
If the burner does not light within 10
seconds, turn the valve off and wait 5
minutes for any gas to dissipate before
repeating the procedure.
1. Press and hold electronic igniter button.
2. Turn the burner control to the high position, press and hold.
When the burner lights, release the electronic igniter button.
3. Continue to depress the burner control knob for 30 seconds
and then release. If the flame goes out, repeat the procedure.
4. Adjust the flame to the desired height with the burner control
knob. Visually check the burner flames as pictured below.
5. If the burner will not light with the electronic igniter, hold a
lit long match or lit long butane lighter to the ignition area of
the burner and continue with step 2.
6. To shut down the burner turn the burner control knob
clockwise to the off position. Then turn the gas off at the
source (propane cylinder valve).
Normal
WARNING
FOR YOUR SAFETY:
Surface of the fire pit can remain
extremely hot for a period after use.
Allow 45 minutes to cool down before
touching or moving the fire pit.
13
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.