Instructions / Assembly

14
Maintenance
Storage between uses:
□ Turn the control knob to the “OFF” position.
□ Disconnect the LP source.
□
□
Storage during periods of extended inactivity or when transporting:
□ Turn the control knob to the “OFF” position.
□
Disconnect the LP source and move to a secure, well ventilated location outdoors. DO NOT store in a location that will exceed 1
25 ° F.
□
□
Care and Cleaning
To enjoy years of outstanding performance from your re pit, make sure you perform the following maintenance
activities on a regular basis:
□ Keep the exterior surface clean.
□
□ While washing your unit, be sure to keep the area around the burner dry at all times. If the gas control is exposed to water, do NOT try to
use it. It must be replaced.
□
□ At least once a year, the unit should be inspected for the presence of spiders, spider webs or other insects.
□
Fire pit does NOT reach the desired temperature.
Heat glow is excessively uneven.
Heat makes popping noises.
□
. Clean the
burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles.
□
□ The burner is made from stainless steel, but extreme heat and a corrosive environment can cause surface corrosion to occur. This can be
tion.
removed with a brass wire brush. Inspect the burner at least annually for cracks, insect nests, excessive corrosion or any other damage.
NOTE:
NOTE:
posits
develop.
Store the re pit upright in an area sheltered from direct contract with inclement weather( such as rain, sleet, hail, snow dust and debris).
If desired, cover the re pit to protect the exterior surfaces and to help prevent debris build up in the air passages.
Store the re pit upright in an area sheltered from direct contract with inclement weather( such as rain, sleet, hail, snow dust and debris).
If desired, cover the re pit to protect the exterior surfaces and to help prevent debris build up in the air passages.