Use and Care Manual

7
ASSEMBLY INSTRUCTIONS
5
5. Load cylinder housing (D) onto pole.
Slide cylinder housing down.
6. Attach three reflector spacers (EE) and three
washers Ø8 (FF) to the top of head assembly (C).
Tighten the reflector spacers.
EE
FF
x 3
Reflector Spacer
x 3
Hardware Used
4
4. Install pole onto three support brackets. Attach
pole to support brackets using six bolts M6 x 30 (DD)
& six M6 flange nuts (BB). Fully tighten all of the screws.
BB
x 6
M6 Flange nut
DD
Bolt M6 x 30
x 6
Hardware Used
DD
BB
6
D
C
EE
FF