Use and Care Manual

8
ASSEMBLY INSTRUCTIONS
7. Unscrew stainless steel bolts M6 x 10 (CC) from
head assembly.
7
9
9. WARNING:Remove protective cover before
assembling.
Note: If necessary for proper alignment of reflector
sections, loosen each bolt prior to further assembly
and retighten after sections are aligned.
B
A
8. Insert hose of head assembly into pole. Secure
head assembly to pole with stainless steel bolts.
Note: The control knob on head assembly should
be above the decal on pole.
8
Hardware Used
CC
x 4
Stainless steel bolt M6 x 10
CC