Use and Care Manual

9
ASSEMBLY INSTRUCTIONS
Hardware Used
FF
JJ
12. Support heater. Slide three washers washer 8 (FF)
over threaded end of spacer. Locate reflector assembly
on 3 spacers. Install three washers 8 on spacers and
securely tighten wing nuts (JJ) but do not overtighten.
x 6
x 3
Wing nut
11. Slide reflector plate onto reflector panels.
Insert one screw M6 x 10 (HH). Slide one washer
M6 x 10 (HH) and
screw on cap nut (II) loosely. Repeat procedure to
complete the assembly of all four sections. Fully tighten
all of the screws in the rolled edge.
II
GG
HH
11
12
JJ
FF
Hardware Used
GG
HH
II
10. Slide two reflector panels together.
Insert one screw M6 x 10
M6 x 10 (HH) and
screw on cap nut (II) loosely.
x 9
x 9
x 9
Screw M6 x 10
Cap nuts
II
GG
HH
10