Instructions / Assembly

10
Operation (continued)
6
Using manual mode
NOTE: Manual mode overrides the motion sensor (C) and
“ON-TIME” control so the light will operate full bright. This
feature only works at night and only for one night at a time.
The motion sensor (C) will reset to motion sensing mode
after 6 hours or sunrise, whichever comes rst. Manual
mode can be toggled on and off using a wall switch.
□ To turn manual mode on, switch the light off
at the wall switch for 1 to 3 seconds and then
back on.
□ To turn manual mode off, switch the light off
at the wall switch for 1 to 3 seconds and then
back on.
NOTE: If the power to the light xture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
Turn the switch
OFF for 1 to 3
seconds
Turn the
switch
back ON
Care and Cleaning
□ To prolong the original appearance, clean the light xture with clear water and a soft, damp cloth only.
□ Do not use paints, solvents, or other chemicals on this light xture. They could cause a premature
deterioration of the nish. This is not a defect in the nish and will not be covered by the warranty.
□ Do not spray the light xture with a hose or power washer.
Troubleshooting
Problem Possible Cause Solution
The light will not come on. □ The light switch is turned off. □ Turn the light switch on.
□ The fuse is blown or the circuit
breaker is turned off.
□ Replace the fuse or turn the
circuit breaker on.
□ Bulbs are loose or burned out. □ Inspect bulbs and replace if
needed.
□ Daylight turn-off (photocell) is in
effect.
□ Recheck after dark.
□ The circuit wiring is incorrect (if this
is a new installation).
□ Verify the wiring is correct.
□ The outside air temperature is close
to the same as a person’s body
heat.
□ Increase the “Sensitivity”
setting.
The light comes on during
the day.
□ The motion sensor may be installed
in a relatively dark location.
□ The light xture is operating
normally under these
circumstances.
□ The “ON-TIME” switch is in the
“TEST” position.
□ Set the “ON-TIME” switch to the
1, 5, or 10 minute setting.