Installation Guide

9 HAMPTONBAY.com
Please contact 1-844-760-3644 for further assistance.
Troubleshooting (continued)
Problem Possible Cause Solution
The new push
button and chime
do not work with
existing push
buttons and
chimes.
The new push button and
chime are not using the
same codes as existing push
buttons and chimes.
The new push button and chime need to be set to work
with existing push buttons and chimes. Please call 1-844-
760-3644 for assistance in changing the codes to work
with existing push buttons and chimes.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Warning: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection againstharmful interferencein a residential installation. This
equipment generates, uses and can radiateradio frequency energyand, if not installed and used in accordance with the instructions,
may causeharmful interferenceto radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does causeharmful interferenceto radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
FCC Responsible Party Name: HeathCo LLC
Address: 2445 Nashville Road, Bowling Green, KY 42101 U.S.A.
Telephone Number: 800-858-8501