Installation Guide

Pre-Installation (continued)

PACKAGE CONTENTS

Part Description Quantity

A Doorbell 1

B Push button 1

*Tune/Sync/Reset button. See Operation, step 2 – Selecting a tune or Troubleshooting for additional information.

Installation

Installing the batteries

□ Push the battery cover tab toward the battery

cover (1) and pull to remove.

□ Install 3 alkaline “C” batteries (not included)

into the doorbell (A). Make sure batteries are

installed according to the diagram inside the

chime.

□ Replace the battery cover (1) onto the

doorbell(A).

NOTE: In typical use, alkaline batteries will last up to

one year.

VOLUME

TUNE-HOLD 1 SEC

SYNC-HOLD 3 SECS

RESET-HOLD 10 SECS

1.5V 1.5V 1.5V

Removing the battery tab

□ Remove the back of the push button (B) by

pushing in the tab on the bottom with a small

screwdriver (not included).

□ Remove the orange battery tab from the push

button (B).