Installation Guide

5 HAMPTONBAY.com

Please contact 1-844-760-3644 for further assistance.

Installation (continued)

Testing the doorbell and push

button placement

□ Temporarily position the push button (B) and

doorbell (A) where they will be mounted.

□ Press the push button (B) to verify the

doorbell(A) and push button (B) work properly.

□ If the doorbell (A) does not sound, move the

doorbell (A) closer to the push button (B) and

test again.

NOTE: Do not permanently mount the push button (B) or

doorbell (A) until they are working properly.

NOTE: The push button and doorbell come synced from

the factory. The range of the wireless doorbell can vary

with location, temperature, and battery condition.

Mounting the push button

Use either screws (AA) or double-sided tape (CC) to

mount the push button (B).

□ To mount with screws (AA), remove the back

of the push button (B) by pushing in the tab

on the bottom with a small screwdriver. Place

the push button back on the door jamb and

mark the two screw holes. Drill two 1/16 in.

(1.5mm) pilot holes. Attach with screws (AA).

□ When attaching the push button (B) with

double-sided tape (CC), remove the paper from

both sides of the double-sided tape (CC) and

apply to a clean surface.

□ Snap on the front of the push button (B).

NOTE: Remove material in screw holes (if needed) before

mounting with screws.

Mounting the doorbell

Use the screws (AA) to mount the doorbell (A).

□ Determine mounting location.

□ Drill one 7/32 in. (5.5 mm) pilot hole and insert

a wall anchor (BB).

□ Insert the screw (AA) into the wall anchor(BB)

leaving about 1/8 in. (3.2 mm) of the screw

threads exposed.

□ Hang the doorbell (A) on the screws (AA) using

the keyholes on the back of the doorbell (A).

VOLUME

TUNE-HOLD 1 SEC

SYNC-HOLD 3 SECS

RESET-HOLD 10 SECS