Instructions / Assembly

6
B
B
Installation - Wired Doorbell (continued)
5
Wiring the doorbell
 Connect the doorbell wires to the doorbell
base (A):
 Wire “F” to screw terminal “FRONT”
 Wire “T” to screw terminal “TRANS”
 Wire “R” to screw terminal “REAR”
 Hang the doorbell cover (A) on the cover pin on
the doorbell base (B).
FRONT TRANS REAR
F
T
R
6
Installing the diode
NOTE: The doorbell will not play the entire musical
tune and the “TUNE” button will not work if a diode is not
installed on the main push button.
 If a diode (CC) is not already installed on the
“FRONT” push button, loosen the two wiring
screws on the back of the existing push button
and wrap each of the ends of the diode (CC)
around each screw. Tighten the screws onto
the diode (CC) and wiring.
Installation - Wireless Doorbell
1
Installing the batteries
NOTICE: When using this doorbell with a transformer, batteries are
not needed and should not be installed even when using wireless
push buttons.
 If the doorbell is not connected to transformer
wires, install 3 alkaline “C”batteries (not
included) into the doorbell base (B). Ensure
batteries are oriented correctly.
NOTE: In typical use, alkaline batteries will last up to
one year.
TYPE “C” TYPE “C”
TYPE “C”
2
Syncing the doorbell and push
button
 Press and release the “SYNC” button on the
doorbell base (B).
 Press the push button within 30 seconds.
 The doorbell base (B) will play a “Beep-Beep” to
indicate the push button is synced.
 Press and release the push button to verify the
doorbell base (B) and push button are synced.
30
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
1 SECOND.
CC
CC
B