Instructions / Assembly

8
Tunes
Westminster
Short Westminster
Piano Westminster
Rockin' Westminster
Whittington
Short End
Relax
Birthday Celebration
Auld Lang Syne
Star Spangled Banner
We Wish You a Merry Christmas
Beethoven's Fifth
Lincoln's Park
Sundance
Jazzy Sax
Ding Dong
Care and Cleaning
Use a dry cloth to clean the doorbell cover and base.
Do not use cleaners or polishes.
Do not use any uids on the doorbell base.
Troubleshooting - Wired Doorbell
Problem Possible Cause Solution
The doorbell does
not sound.
The transformer may
not be working properly.
Test transformer voltage output with a volt meter. Set
the volt meter to read A/C voltage. Voltage should read
between 18 - 22 volts A/C on the low voltage side of the
transformer when the doorbell is NOT playing. If the volt
meter reads below 18 volts, replace the transformer.
The push button may
not be working properly.
Remove the push button that is not working from the
door frame. Disconnect the wires from the terminals and
touch the bare wires together. If the doorbell sounds, the
push button is defective. Replace the push button.
The doorbell may not be
working properly.
Disconnect the wire from the terminal marked “TRANS”.
While someone presses the push button at the front
door, quickly touch the “TRANS” wire to the terminal
marked “FRONT”. You will see a small spark if the push
button, wiring, and transformer are operating properly.
Repeat the steps for the “REAR” terminal and the rear
push button. If the wiring between the transformer and
the push button(s) checks out properly, replace the
doorbell.