Instructions / Assembly

ManualsBrandsHampton Bay ManualsDoorbell KitsWireless Battery Operated Door Bell Kit with 1-Push Button in White

5 HAMPTONBAY.com

Please contact 1-844-760-3644 for further assistance.

Installation (continued)

Testing the doorbell and push

button placement

Ƒ Temporarily position the push button (B) and

doorbell (A) where they will be mounted.

Ƒ Press the push button (B) to verify the

doorbell(A) and push button (B) work properly.

Ƒ If the doorbell (A) does not sound, move the

doorbell (A) closer to the push button (B) and

test again.

NOTE: Do not permanently mount the push button (B) or

doorbell (A) until they are working properly.

NOTE: The push button and doorbell come synced from

the factory. The range of the wireless doorbell can vary

with location, temperature, and battery condition.

Mounting the push button

Use either screws (AA) or double-sided tape (DD) to

mount the push button (B).

Ƒ To mount with screws (AA), remove the back

of the push button (B) by pushing in the tab

on the bottom with a small screwdriver. Place

the push button back on the door jamb and

mark the two screw holes. Drill two 1/16 in.

(1.5mm) pilot holes. Attach with screws (AA).

Ƒ When attaching the push button (B) with

double-sided tape (DD), remove the paper from

both sides of the double-sided tape (DD) and

apply to a clean surface.

Ƒ Snap on the front of the push button (B).

NOTE: Remove material in screw holes (if needed) before

mounting with screws.

Mounting the doorbell

Ƒ Determine mounting location.

Ƒ Drill one 7/32 in. (5.5 mm) pilot hole and insert

a wall anchor (CC).

Ƒ Insert the screw (BB) into the wall anchor(CC)

leaving about 1/8 in. (3.2 mm) of the screw

threads exposed.

Ƒ Using the keyhole on the doorbell back

plate(1), hang the back plate (1) on the

screw(BB).

Ƒ Mark the second screw location in the slot in

the doorbell back plate (1). Remove the back

plate (1) from the keyhole screw (BB).

Ƒ Drill one 7/32 in. (5.5 mm) pilot hole and insert

a wall anchor (CC).

Ƒ Hang the doorbell back plate (1) on the keyhole

screw (BB) and insert the second screw (BB)

into the second wall anchor (CC).

Ƒ Ensure the doorbell back plate (1) is level and

tighten the second screw (BB) securely.