Installation Guide
Table Of Contents
- Slide Number 1
- Slide Number 2
- Slide Number 3
- Slide Number 4
- Slide Number 5
- Slide Number 6
- Slide Number 7
- Slide Number 8
- Slide Number 9
- Slide Number 10
- Slide Number 11
- Slide Number 12
- Slide Number 13
- Slide Number 14
- Slide Number 15
- Slide Number 16
- Slide Number 17
- Slide Number 18
- Slide Number 19
- Slide Number 20
- Slide Number 21
- Slide Number 22
- Slide Number 23
- Slide Number 24
1
Mounting the hardware
Thread the fixture screws (EE) into the provided
holes of the mounting bracket (FF).
Thread the hex nuts (BB) onto the fixture screws
(EE). Do not tighten the hex nuts (BB) at this time.
Pull the supply wires out from the outlet box and
mount the mounting bracket (FF) to the outlet box
using the mounting screws (DD).
Place the canopy (A) over the outlet box and onto
the fixture screws (EE).
Adjust the hex nuts (BB) until the fixture screws (EE)
protrude out from the canopy (A) 1/4 in.
Remove the canopy (A) and secure the position of
the fixture screws (EE) by tightening the hex nuts
(BB) against the mounting bracket (FF).
5
2
Adjusting the length
Adjust the socket rod to desired length.
Tighten the canopy screw, attached to the canopy
(A), to ensure the socket rod is attached to the
canopy (A).
Installation
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further
assistance.
FF
DD
BB
EE
A