Instructions / Assembly
11 HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Troubleshooting (continued)
Problem Possible Cause Solution
The light comes on for no
apparent reason.
□ The motion sensor may be sensing
small animals or automobile trafc.
□ Decrease the “Sensitivity”
setting.
□ The “Sensitivity” setting is set too
high.
□ Decrease the “Sensitivity”
setting.
□ The “DUALBRITE” switch is in the
3 hour, 6 hour, or dusk-to-dawn
setting.
□ The light xture is operating
normally under these circum-
stances.
□ The outside temperature is much
warmer or cooler than a person’s
body heat (summer or winter).
□ Decrease the “Sensitivity”
setting.
□ The light xture is wired through a
dimmer or timer.
□ Do not use a dimmer or timer to
control the light xture. Replace
the dimmer or timer with a
standard on/off wall switch.
The lights stay on
continuously.
□ The motion sensor may be picking
up a heat source, such as an air
vent, dryer vent, or brightly painted,
heat-reective surface.
□ Decrease the “Sensitivity”
setting.
□ The motion sensor is in manual
mode.
□ Switch the motion sensor to
auto. See Using manual mode
on page 10.
□ Light control is in DualBrite
®
mode. □ Slide DualBrite
®
switch to OFF
position.
□ The “Sensitivity” setting is set too
high.
□ Decrease the “Sensitivity”
setting.
□ The light xture is wired through a
dimmer or timer.
□ Do not use a dimmer or timer to
control the light xture. Replace
the dimmer or timer with a
standard on/off wall switch.
□ The light xture is on the same
circuit as a motor, transformer, or
uorescent bulb.
□ Install the light xture on a cir-
cuit without motors, transform-
ers, or uorescent bulbs.
The lights ash on and off. □ Light control is in the TEST mode
and warming up.
□ Flashing is normal under these
conditions.
□ Heat is being reected from other
objects and may be turning the mo-
tion sensor on and off.
□ Decrease the “Sensitivity”
setting.
The lights ash once then stay
off in manual mode.
□ Nearby large, light-colored objects
reecting light may trigger the shut-
off feature.
□ Do not point other lights at the
sensor.