Instructions / Assembly
6
Installation (continued)
3
Wiring the light fixture
NOTE: This light xture can be wired to control another
standard or motion sensing light xture(s). See Wiring
Options for additional wiring methods.
CAUTION: DO NOT remove wire connector from RED
wire or connect the RED wire unless you want to control
other lights from this motion sensor xture.
□ Connect the junction box wires to the wires on
the light xture (A).
□ Using the wire connectors (BB):
□ Connect all white wires together.
□ Connect all black wires together.
□ Recommended grounding method: Attach
a copper wire pigtail (1) (not included) to
the green ground screw on the mounting
bracket (FF).
□ Connect all ground wires to the pigtail
wire (1) attached to the green ground
screw.
Black to black
White to white
One motion sensing light
Ground to ground
Light
Black to black
White to white
Ground to ground
Light Light
Two motion sensing lights (working independently)
4
Mounting the light fixture base
□ Push the wires into the juction box.
□ Slide the light xture (A) onto the large
mounting screws (DD) and tighten the
decorative xture nuts (CC) against the light (A).
□ See the Operation section for testing and
setup.
□ Caulk around xture base with silicone
weather sealant.
BB
CC
CC
FF
A
A
DD
1