Instructions / Assembly
7 HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Installation (continued)
5
Installing the light bulb
□ Install the bulb (tungsten incandescent,
medium base, type “A”, 60 watt maximum -
not included) into the light xture (A).
□ Place the xture cap (B) onto the light xture (A).
□ Secure the xture cap (B) with the two
decorative screws (EE).
Wiring Options
1
Determining maximum wattage
when adding light fixtures
NOTE: All wiring should be run in accordance with
the National Electrical Code through conduit or another
acceptable means. Contact a qualied electrician if there is
any question as to the suitability of the system.
When controlling an additional light xture(s), the
maximum wattage of the motion sensor (C) on this light
xture (A) should be observed. See the illustration to the
right for an example of a maximum lamp wattage load
calculation.
IMPORTANT: When determining the maximum lamp wattage
rating of the light xture to be controlled, refer to the maximum lamp
wattage label on the xture and not the wattage rating on the lamp(s)
currently installed in the xture.
Maximum Load for
Motion Sensor –
360 Watts
Maximum Lamp
Wattage Rating
for Light Fixture –
60 Watts
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
TOTAL Load for
Motion Sensor –
260 Watts (100 Watts Remaining)
CONTROLLING Fixture
CONTROLLED Fixture 1
CONTROLLED Fixture 2
2
Controlling a standard light
fixture(s)
IMPORTANT: Total xture ratings must not exceed 360 Watts (3.0 A).
When wiring to control a standard light xture:
□ Strip the red wire on the light xture (A) and
connect it to the standard light’s black wire.
□ Connect all white wires together.
□ Connect all ground wires together.
Wiring the motion sensing light
to control a standard light
Black to
black
Motion
Sensing
Light
Standard
Light
White to white
Ground to ground
Red to
black
EE
B
A