Instructions / Assembly

8
Wiring Options (continued)
3
Controlling a motion sensing
light fixture(s)
IMPORTANT: Total xture ratings must not exceed 360 Watts (3.0 A).
When wiring to control another motion sensing light
xture (Primary / Controlled):
Strip the red wire in both light xtures.
Connect the red wire of the controlling
(primary) xture (A) to the red and black wires
of the controlled (controlled) xture.
Connect all white wires together.
Connect all ground wires together.
Wiring the motion sensing light
to control another motion sensing light
Black to
black
Primary
Light
Controlled
Light
White to white
Ground to ground Black to red and black
Red
to black
4
Wiring motion sensing lights to
control each other
IMPORTANT: Total xture ratings must not exceed 360 Watts (3.0 A).
When wiring so either motion sensor turns on both
motion lights (Primary / Primary):
Strip the red wire in both light xtures.
Connect the red wire of one xture to the red
wire of the second xture.
Connect all white wires together.
Connect all black wires together.
Connect all ground wires together.
NOTE: In most installations, an additional wire (same
gauge as existing house wire) will have to be installed in
the house to connect the two xtures as primary / primary.
Wiring multiple motion sensing lights
to control each other
Black to black
Primary
Light
Primary
Light
White to white
Ground to ground
Red
to red
Operation
1
Setting the sensor for testing
NOTE: When the “ON-TIME” switch is set to the “TEST”
position, the light xture will operate during the day or
night. The light will stay on for 5 seconds after all motion
is stopped.
Turn the power on at the circuit breaker or
fuse and turn on the wall switch.
Set the “ON-TIME” switch to the “TEST”
position.
Set the “DUALBRITE” switch to the “OFF”
position.
Turn the “SENS” (sensitivity) control to the “–”
position.
NOTE: The motion sensor will need to completely warm
up (90 seconds) before beginning the setup process.
1 5 10
MINUTES
OFF 3 6 DUSK
HOUR TO
DAWN
T
E
S
T
+
SENS
A