Instructions / Assembly

9 HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Operation (continued)
2
Determining the motion sensor
coverage area
□ Perform a “walk test”: walk in an arc in front
of the motion sensor (C).
□ Watch the light (A). The light (A) will come on
when motion has been detected.
□ Stop, wait for the light (A) to turn off, and then
begin walking again.
□ Continue this process until the detection zone
has been established.
3
Adjusting the SENS control
□ To increase the detection zone, turn the
“SENS” control toward the “+” position.
□ To decrease the detection zone, turn the
“SENS” control toward the “–” position.
NOTE: The motion sensor is more sensitive to motion
moving across the front of the sensor. The motion sensor
is less sensitive to motion moving directly toward the front
of the sensor.
NOTE: The higher the “SENS” (sensitivity) setting, the
greater the possibility of false triggering. To reduce false
triggering, turn the “SENS” control toward the “–” setting.
1 5 10
MINUTES
OFF 3 6 DUSK
HOUR TO
DAWN
T
E
S
T
– +
SENS
4
Adjusting the ON-TIME switch
NOTE: The “ON-TIME” switch determines the amount of
time the light will stay on full bright after all motion has
stopped.
□ Set the “ON-TIME” switch to the 1, 5, or 10
minute position.
1 5 10
MINUTES
OFF 3 6 DUSK
HOUR TO
DAWN
T
E
S
T
– +
SENS
5
Adjusting the DUALBRITE
switch
NOTE: The “DUALBRITE” switch determines the amount
of time the lights stay on at an accent level after sundown.
Switching this setting to “OFF” will not affect the “ON-
TIME” setting.
□ Set the “DUALBRITE” switch to OFF, 3 hours, 6
hours, or dusk-to-dawn (sunset to sunrise).
1 5 10
MINUTES
OFF 3 6 DUSK
HOUR TO
DAWN
T
E
S
T
– +
SENS
A
A
C
A