Installation Guide

WARNING: Risk of Electric Shock. Install 10 feet or more from a pool, spa or fountain. Be protected by routing in
close proximity to the luminaire or tting or next to a building structure such as a house or deck; Not to be buried
except for a maximum 6 inches in order to connect the main low voltage cable; and have the length cut off so that it is
connected to a connector within 6 inches from a building structure, a luminaire or tting.
FOR USE WITH LANDSCAPE LIGHTING SYSTEMS ONLY
THIS DEVICE IS ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE SUITABILITY
OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL INSPECTION AUTHORITIES HAVING
JURISDICTION
EASY TO INSTALL
1. The Quick Clip connector replaces existing connectors and allows installation anywhere along the low voltage cable.
2. Connect existing xture wires to “pigtail” wires of Quick Clip connector, using the twist-on wire connectors provided. (Fig.1)
3. Place the wire connector on opposite sides of the low voltage cable where the xture will be located. (Fig. 1)
4. Press the wire connector together until fully seated and locked around the cable. Pre-set prongs will pierce the cable insulation
and establish contact.
5. Once the connector is in place, it is recommended to wrap it with electrical tape (not included) for additional protection. (Fig. 2)
Additional wire can be purchased at your local hardware retailer.
Item #1001 491 871
Model #HD28353
Quick Clip connector
Wire connectors
Fixture
Low voltage
cable
Existing xture wires
Fig. 1 Fig. 2