Installation Guide

Item #1002 753 108
Model #HD33677
Use and Care Guide
LOW VOLTAGE PATHLIGHT KIT
Part Description Quantity
A
Pathlight head
6
B
Pathlight lens
6
C
Pathlight post
6
D
Pathlight connector
6
E
Pathlight spike
6
F
6W transformer
1
G
Cable
1
H
Control box
1
PACKAGE CONTENTS
Assembly and Installation
1
Attaching and installing the pathlight
WARNING: Never push the xture into the ground by the xture’s head (A) or use a
hammer to insert the spike (E) into the ground.
CAUTION: Safe for outdoor operation.
WARNING: To reduce the risk of FIRE OR INJURY TO PERSONS:
WARNING: Do not operate the luminaire tting with a missing or damaged lens
or bulb protector.
Carefully remove the xture from its protective packaging.
Attach the lens (B) to the post (C) and insert the spike (E) into the
post (C).
Attach the cap (A) by screwing it on top of the lens (B)
WARNING: Install in accordance with all local codes and ordinances.
Only for use with low voltage power units with a maximum output rating of 15V,
300W per secondary.
FOR LANDSCAPE LIGHTING SYSTEMS ONLY. OUTDOOR USE ONLY. THE DEVICE IS
ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL
INSPECTION AUTHORITIES HAVING JURISDICTIO
N.
PATHLIGHT ETL LISTED UNDER MODEL # U000-1923
Please read and save these instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
Lighted lamp is HOT!
G
2
Connecting the wires
WARNING: The wire connector (D) contacts have sharp edges for piercing the
main low voltage cable. To avoid injury, do not touch the metal contacts.
CAUTION: The wire from the low voltage power unit shall be 12-18 AWG type
underground low Energy Circuit Cable or SPT2W.
IMPORTANT:
Protect the wiring by routing it in close proximity to the light tting, or next to a
building structure such as a house or deck.
The landscape wire and connector can also be hidden under stone or buried
under grass at a maximum depth of 6 in. (15.24 cm).
Do not submerge the xture in water.
WARNING: Risk of Electric Shock. Install all luminaires 10 ft. (3.05 m) or more
from a pool, spa or fountain.
A
B
C
E
D
F
A
B
C
E
H
Place the wire connector (D) on opposite sides of the low
voltage cable (G) where the xture will be located.
Align and t the main low voltage cable (G) vertically to the
slot of wire connector (D) as shown.
Press the wire connector (D) together until fully seated and
locked around the cable (G). Pre-set prongs will pierce the
cable insulation and establish contact. Turn on the power unit.
If the light xture does not turn on, repeat previous steps.
Once the clip-on connector (D) is in place, wrap it with
electrical tape for additional protection.
D
CAUTION: BE CAREFUL! THE WIRE STABS ARE VERY SHARP!

Summary of content (6 pages)