Warranty

Item #1000 000 000
Model #HD39400
Use and Care Guide
SOLAR PATHLIGHT
PACKAGE CONTENTS
Assembly and Installation
1
Attaching and installing the light
3
Replacing the battery
2
Installation tips
Please read and save these instructions
Part Description Quantity
A
Top Cap
1
B
Lens
1
C
Top Post
1
D
Middle Post
1
E
Botom Post
1
F
Spike
1
q If the solar panel is covered by a protective lm, remove it before using
the product. Remove the pull-tab from the battery door. Place the solar
light in a location where it can receive a full 8 hours of sunlight to allow
the rechargeable battery/batteries to reach maximum capacity.
q If the soil is of a loose, sandy or organic type, grasp the post with both
hands near the spike and rmly push into the ground.
q If the soil is hard, pour some water onto the ground to soften it.
q If the soil is stony, soften the ground with a rake or shovel and remove
large rocks. Dig a small hole, insert the xture spike, replace the soil and
tap down.
q Never push the xture into the ground by the xture head.
q Assemble top post (C) to middle post (D) and bottom post (E).
q Assemble the post to the spike (F).
q Place the light xture on the shepherd hook.
qRemove the 3 screws from the battery cover.
qRemove the battery cover.
qRemove the old battery and replace with 1 new AA NiMh
rechargeable battery of same or greater mAh.
(USE RECHARGEABLE BATTERIES ONLY).
qBe sure to insert the battery in the proper direction.
qReplace the battery cover.
qReplace the 3 screws.
qReplace the light xture on the post.
C
A
B
F
E
D
C
A
D
E
F
Battery
Battery cover
Screws
A
WARNING: When planting the spike ensure that there are no underground utility
lines or pipes.
NOTE: This operation should be done in the morning on a sunny day. This will allow
the light to receive a full 8 hours of sunlight so that the rechargeable battery can reach
maximum capacity.
Note : Clean the battery contacts and those of the device prior to battery installation.
B