Manualshelf

Instructions / Assembly

ManualsBrandsHampton Bay ManualsLandscape Flood Lights17-Watt Millennium Black Adjustable Light Color Outdoor Integrated LED Landscape Flood Light
1234567
1
PACKAGE CONTENTS
A – Knob x1 C – Wire Connector x1 D – Ground Stake (6.693 in.) x1
B – Lamp Body x1 (with 12 in. wire attached to lamp body)
Assembly and Installation
1
Attaching and installing the light
2
Connecting the wires
WARNING: Never push the fixture into the ground by the lamp body (B)
or use a hammer to insert the ground stake (D) into the ground.
□ Insert the fixture wire on the wire connector (C) into the groove located on
the top of the ground stake (D).
□ Screw the lamp body (B) onto the top of the ground stake (D). Ensure the
fixture wire on the wire connector (C) stays in the center of the groove of the
ground stake (D) to avoid damage to the fixture wire.
□ Prepare a hole in the installation location. Use a tool such as a screwdriver
(not included) to prepare the installation hole to ensure the hole is not
larger than the ground stake (D).
□ Install the fixture in the ground by pushing on the foot step (1) on the
ground stake (D). Do not push on the lamp body (B).
□ The lamp body (B) can rotate up and down 126 degrees.
WARNING: The wire connector (C) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch the
metal contacts.
CAUTION: The wire from low voltage power unit should be 12-16 AWG
type underground low Energy Circuit Cable.
IMPORTANT:
□ Protect the wiring by routing it in close proximity to the light
fitting, or next to a building structure such as a house or a deck.
□ The landscape wire and connector can also be hidden under
stone or buried under grass at a maximum depth of 6 in. (15.24
cm).
□ Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□ Do not submerge the fixture in water.
□ Place the wire connector (C) on opposite sides of the low voltage cable
(not included) from the transformer (not included) where the fixture will
be located.
□ Align and fit the main low voltage cable vertically to the slot of the wire
connector (C).
□ Press the wire connector (C) together until it is locked around the main
low voltage cable. The pre-set prongs will pierce the cable insulation
and establish contact with the electrical wire inside.
□ Once the wire connector (C) is in place, it is recommended to wrap it
with electrical tape (not included).
□ After all fixtures are installed, turn on the transformer.

Summary of content (7 pages)