Instructions / Assembly

1
Use and Care Guide
LED LOW VOLTAGE PATH LIGHT
PACKAGE CONTENTS
A –Cap x1 B – Lamp Body x1 C – Screw x2 D – Post x1 E - Wire Connector (with 12 in. F – Ground Stake (6.693 in.) x1
wire attached to lamp body) x1
Assembly and Installation
1
Attaching and installing the light
2
Connecting the wires
WARNING: Never push the fixture into the ground by the cap (A) or use a
hammer to insert the ground stake (F) into the ground.
□ Use a Philips screwdriver (not included) to unscrew the two screws (C)
from the cap (A).
□ Use a Philips screwdriver to screw the two screws (C) through the lamp
body (B) back into the holes located on the cap (A).
□ Screw the post (D) onto the lamp body (B).
□ Insert the fixture wire on the wire connector (E) into the groove located
on the top of the ground stake (F).
□ Screw the ground stake (F) into the post (D). Ensure the fixture wire on
the wire connector (E) stays in the center of the groove of the ground
stake (F) to avoid damage to the fixture wire.
□ Prepare a hole in the installation location. Use a tool such as a
screwdriver to prepare the installation hole to ensure that the hole is
not larger than the ground stake (F).
□ Install the fixture in the ground by pushing on the foot step (1) on the
ground stake (F). Do not push on the cap (A).
WARNING: The wire connector (E) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch the
metal contacts.
CAUTION: The wire from low voltage power unit should be 12-16 AWG
type underground low Energy Circuit Cable.
IMPORTANT:
□ Protect the wiring by routing it in close proximity to the light fitting,
or next to a building structure such as a house or a deck.
□ The landscape wire and connector can also be hidden under stone
or buried under grass at a maximum depth of 6 in. (15.24 cm).
□ Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□ Do not submerge the fixture in water.
□ Place the wire connector (E) on opposite sides of the low voltage cable
(not included) from the transformer (not included) where the fixture will
be located.
□ Align and fit the main low voltage cable vertically to the slot of the wire
connector (E).
□ Press the wire connector (E) together until it is locked around the main
low voltage cable. The pre-set prongs will pierce the cable insulation
and establish contact with the electrical wire inside.
□ Once the wire connector (E) is in place, it is recommended to wrap it
with electrical tape (not included).
□ After all fixtures are installed, turn on the transformer.
Item #1002 670 654
Model #JEF1501L-3