Installation Guide

FINISHING UNFINISHED CABINETS
DAR ACABADO A GABINETES SIN ACABADO
Fill screw holes made in the face frame stiles with wood putty. Sand the cabinets and prep for stain. Use a tack cloth to thoroughly wipe the surface and
remove any excess dust. A surface that is improperly prepared will not stain correctly. Stain or paint your cabinets according to the nish manufacturer's
recommended instructions.
Rellena con masilla para madera los oricios de tornillos hechos en los travesaños del marco. Lija los gabinetes y prepáralos para el tinte. Usa un paño adherente para limpiar bien la supercie y remover
cualquier exceso de polvo. Una supercie que no se prepare adecuadamente no absorberá el tinte correctamente. Tiñe o pinta tus gabinetes según las instrucciones recomendadas por el fabricante para el acabado.
Pull distance: 42" min. to 45" max.
What is pull distance?
Pull distance refers to the distance from the corner where two
walls meet out to the furthest side panel of the blind base cabinet.
Distancia de separación: 1.07 m mín. hasta 1.14 m máx.
¿Qué es la distancia de separación?
La distancia de separación se reere a la distancia desde la esquina donde se unen
las dos paredes hasta el panel lateral más lejano del gabinete de base ciega.
3" FILLER
RELLENO DE 7.6 CM
2" HARDWARE CLEARANCE
ESPACIO DE 5.1 CM PARA LOS HERRAJES
= OPEN SPACE
= ESPACIO LIBRE
ADJACENT CABINET
GABINETE ADYACENTE
BLIND BASE CABINET
GABINETE DE BASE CIEGA
36"
42"– 45"
COUNTERTOP CLEAT / LISTÓN DEL MOSTRADOR
WALL / MUR / PARED
WALL / PARED
BLIND BASE CABINET INSTALLATION
INSTALACIÓN DEL GABINETE DE BASE CIEGA
Place the blind base cabinet into the corner. Make sure the
cabinet is pulled out from the corner the correct distance
specied on your design layout.
Place the adjacent cabinet into place. You may need to install
a base ller to provide the proper clearance for doors or
decorative hardware.
Coloca el gabinete de base ciega en la esquina. Asegúrate de que el gabinete
esté separado de la esquina la distancia correcta según se especica en el diseño.
Coloca el gabinete adyacente en su posición. Puedes necesitar instalar un relleno
de base para lograr el espacio adecuado para puertas o herrajes decorativos.
C-CLAMP
ABRAZADERA EN C
WALL
PARED
BLIND BASE CABINET
GABINETE DE BASE CIEGA
3" FILLER
RELLENO DE 7.6 CM
ADJACENT CABINET
GABINETE ADYACENTE