Instructions / Assembly

2
Assembly and Installation
3
Attaching and
installing the light
4
Connecting the wires
□ Insert the fixture wire on the wire connector (B) into the groove located
on the top of the ground stake (C).
□ Ensure the fixture wire on the wire connector (B) stays in the center of
the groove to avoid damage to the fixture wire. Screw the ground stake
(C) into the lamp body (A).
□ Prepare a hole in the installation location. Use a tool such as a
screwdriver (not included) to prepare the installation hole to ensure the
hole is not larger than the ground stake (C).
□ Install the ground stake (C) in the ground by pushing on the lamp body
(A).
If you need the path light to stay on
□ Slided the swith (2) to the ON, then the path light will stay on.
□ If you need to turn off the path light, you can slided the swith (2) to the
OFF.
WARNING: Never push the fixture into the ground by the lamp body (A)
or use a hammer to insert the ground stake (C) into the ground.
WARNING:
The wire connector (B) contacts have sharp edges for
piercing the
main low voltage cable. To avoid injury, do not touch
the metal contacts.
CAUTION: The wire from low voltage power unit should be 12-16
AWG type underground low Energy Circuit Cable.
IMPORTANT:
□ Protect the wiring by routing it in close proximity to the light
fitting, or next to a building structure such as a house or a
deck.
□ The landscape wire and connector can also be hidden under
stone or buried under grass at a maximum depth of 6 in.
(15.24 cm).
□ Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□ Do not submerge the fixture in water.
□ For the emergency use, when disconnected from the
transformer (disconnect the power supply), it can still be used
for 24 times induction.
□ Place the wire connector (B) on opposite sides of the low
voltage cable (not included) from the transformer (not
included) where the fixture will be located.
□ Align and fit the main low voltage cable vertically to the slot of
the wire connector (B).
□ Press the wire connector (B) together until it is locked around
the main low voltage cable. The pre-set prongs will pierce the
cable insulation and establish contact with the electrical wire
inside.
□ Once the wire connector (B) is in place, it is recommended to
wrap it with electrical tape (not included).
□ After all fixtures are installed, turn on the transformer.