Instructions / Assembly

1
Use and Care Guide
LOW VOLTAGE LED ROCK LIGHT
PACKAGE CONTENTS
A – Lamp Body x1 B – Wire Connector x1 (with 12 in. wire attached to lamp body)
Assembly and Installation
1
P
lacing and setting the lamp body
2
Connecting the wires
WARNING
: Never push the fixture into the ground by the lamp
body (
A).
NOTE
: The
ground stake (not included)
can be installed at the
bottom of the lamp
body (A) as your various installation
requirements.
□ Put the lamp body (A) in the position you need.
- If you need to use the ground stake (not included)
□ Insert the fixture wire on the wire connector (B) into the groove
located on the top of the ground stake (not included).
□ Ensure the fixture wire on the wire connector (B) stays in the center
of the groove to avoid damage to the fixture wire. Screw the ground
stake (not included) into the lamp body (A).
□ Prepare a hole in the installation location. Use a tool such as a
screwdriver (not included) to prepare the installation hole to ensure
the hole is not larger than the ground stake (not included).
□ Install the ground stake (not included) in the ground by pushing on
the lamp body (A).
WARNING: The wire connector (B) contacts have sharp edges for
piercing the
main low voltage cable. To avoid injury, do not touch
the metal contacts.
CAUTION: The wire from low voltage power unit should be 12-16
AWG type underground low Energy Circuit Cable.
IMPORTANT:
□ Protect the wiring by routing it in close proximity to the light
fitting, or next to a building structure such as a house or a
deck.
□ The landscape wire and connector can also be hidden under
stone or buried under grass at a maximum depth of 6 in.
(15.24 cm).
□ Do not install the fixture within 10 ft. of a pool, spa, or fountai
n.
□ Do not submerge the fixture in water.
□ Place the wire connector (B) on opposite sides of the low voltage
cable (sold separately) from the transformer (sold separately)
where the fixture will be located.
□ Align and fit the main low voltage cable vertically to the slot of the
wire connector (B).
□ Press the wire connector (B) together until it is locked around the
main low voltage cable. The pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
□ Once the wire connector (B) is in place, wrap it with electrical tape
(sold separately).
□ After all fixtures are installed, turn on the transformer.
Item # 1007 897 375
Model # LBM1501LX-02