User Guide

7
Please contact 1-855-HD-HAMPTON for further assistance.
Installation - New Construction (continued)
3
Connecting the house and fan wires.





Locate the wire cover inside of the housing. Figure 1.
Loosen the screw to remove the wire cover (AA)
Remove the nut from the 120 V AC house wire.
Use the quick connector- 3 pin (H) and quick connector
-2 pin (I) to secure the 120V AC house wirings to the fan
wires as shown in the wiring diagram on page 3. Figure 2.
Carefully push the connected wires back into the wiring
compartment of the fan housing (A). Reattach the nut from
the inside of housing(A) and make sure wires and terminals
in the wiring compartment of the fan housing (A). Figure 3.
Reattach the wire cover (AA) and secure it in place with
the screw. Figure 4.
6
Finish the ceiling work
 After the electrical and construction inspection is
complete, finish the ceiling work.
 Cut the ceiling hole with the cut-hole template (J) or the
size 10 5/8inch (270*270mm). Ceiling hole should be
aligned with the inside edge of fan housing.
5
Select the airflow
 Select desired airflow (80 CFM or 110 CFM) by sliding the
toggle switch on the bottom of the housing (A).
CAUTION: If the electrical wires do not match the colors
listed, you must determine what each house wire represents
before connecting. You may need to consult an electrical
contractor to determine safely.
TEMPLATE
10 5/8inch
10 5/8inch
80 110
① ①
③ ④
②
AA Wire cover
Green
Black
White
HOMEDEPOT.COM
4
Connect the duct


Connect a 6 in. circular duct (not supplied) and vent to the
duct connector. Secure it with duct tape (not supplied) or a
clamp (not supplied) to make the connection secure and
air tight.
Turn on the power source. Check the fan for any abnormal
sound or vibration.
NOTE: If you have to connect to 4in.
circular duct, please use a 6in. to 4in.
duct adapter (G).
CAUTION: After checking the
fan, please remember to turn
off the power before next
installation step.
 Important: Cover and seal up all gaps with duct tape
NOTE: That it is common practice in heating and ventilation
systems using sheet metal ductwork and fittings or flexible duct
work tubing to use duct tape or aluminum tape to ensure air
tight seals and improve efficiency.
Duct tape Duct tape Gaps
Green
Black
White
Green