Installation Guide

6
Care and Cleaning
Use a dry or slightly dampened clean cloth to wipe the surface of the fixture. Do not use any cleaners with
chemicals, solvents, or harsh abrasives. If necessary, use a mild soap with water to clean off any dirt or stains.
Troubleshooting
Problem Possible Cause Solution
The lights do not turn on. □ The wall switch and/or circuit breaker
is off.
□ A wire connection is loose or incorrectly
connected.
□ Turn on the wall switch or
circuit breaker.
□ Access the outlet box and fix
the wire connections.
The fuse blows or the circuit
breaker trips when the
lights are turned on.
□ There are crossed wires or the power
wire is not grounded.
□ Access the outlet box and fix
the wire connections.
Maintenance
REPLACING THE LED DRIVER
IMPORTANT: Do NOT disassemble product. This operation is only for the replacement of a faulty LED Driver.
IMPORTANT: It is recommended that the replacement of an LED driver be completed by a qualified electrician.
CAUTION: Turn off main power at fuse or circuit breaker box.
Disassembly:
1. Remove fixture from wall by removing (2) canopy screws.
2. Disconnect LED driver power wires from power supply wires in junction box by removing wire nuts.
3. Separate LED driver from canopy by removing (2) screws.
4. Disconnect (2) driver wires from fixture wires.
NOTE: Mark fixture wires with tape to match black wire
with parallel fixture head wires on one side, and red wire
with parallel fixture head wires on the other side.
Re-assembly:
1. Using new LED driver, connect red and black wires to
matching parallel fixture head wires with wire nuts.
2. Re- attach driver to canopy with 2 screws.
3. Connect black wire to black wire, white to white and
ground (Copper) to ground (Green or copper)
4. Tuck supply wires in junction box.
5. Connect canopy to junction gem bar with (2) canopy screws.
6. Restore power to the fixture.
Junction Box
Driver
Canopy
Gem Bar
Supply Wires