Instructions / Assembly

Assembly

Preparing the canopy Preparing the motor

Remove the canopy bottom cover (C) from the canopy (B) by

turning the canopy bottom cover (C) counterclockwise.

Remove the mounting bracket (A) from the canopy (B) by

loosening canopy mounting screws (DD) a half turn from the

screw head. Next, turn the canopy (B) counterclockwise to

remove the mounting bracket (A) from the canopy (B).

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Remove the cotter pin (EE) and clevis pin (FF), and loosen

the two collar set screws (GG) from the fan motor assembly

(F) collar.

Assembling the fan

WARNING: Failure to properly install the cotter pin (EE) could

result in the fan loosening and possibly falling.

NOTE: If a longer downrod is needed (not included), take out

the screw located in the hanger ball, lower the hanger ball and

remove the pin. Remove all three pieces from the downrod, and

assemble them onto the new longer downrod before proceeding

to the downrod installation.

Route the wires through the coupling cover (E), the canopy

bottom cover (C) and the canopy (B) and then through the

hanger ball/downrod assembly (D).

Align the holes at the bottom of the hanger ball/downrod

assembly (D) with the holes in the collar on top of the fan

motor assembly (F).

Carefully insert the clevis pin (FF) through the holes in the

collar and the hanger ball/downrod assembly (D). Be careful

not to jam the clevis pin (FF) against the wiring inside the

hanger ball/downrod assembly (D).

Insert the cotter pin (EE) through the hole near the end of

the clevis pin (FF) until it snaps into the locked position.

Firmly tighten the two collar set screws (GG) on top of the

fan motor assembly (F).