Instructions / Assembly

ASSEMBLY INSTRUCTIONS
Hardware Used
FF
JJ
12. Support heater. Slide three washers washer ĭ8 (FF)
over threaded end of spacer. Locate reflector assembly
on 3 spacers. Install three washers 8 on spacers and
securely tighten wing nuts (JJ) but do not overtighten.
x 6
x 3
Wing nut
11. Slide reflector plate onto reflector panels.
Insert one screw M6 x 10 (HH). Slide one washer
ĭ6 (GG) over threaded end of screw M6 x 10 (HH) and
screw on cap nut (II) loosely. Repeat procedure to
complete the assembly of all four sections. Fully tighten
all of the screws in the rolled edge.
II
GG
HH
TT
11
12
JJ
FF
13. To improve the stability, bucket must be filled with
sand/soil and water.
13
8
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Fill sand/soil
and water