Instructions / Assembly
2
Table of Contents
Safety Information ..................................2
Warranty ..........................................2
Pre-Installation .....................................3
Planning Installation ...............................3
Tools Required ....................................3
Hardware Included .................................3
Package Contents .................................4
Installation ........................................5
Maintenance .......................................7
Care and Cleaning ..................................8
Troubleshooting ....................................8
Service Parts .......................................9
Read all safety precautions and installation instructions carefully
before installing or servicing this xture. Failure to comply with these
instructions could result in potentially fatal electric shock and/or
property damage.
It is recommended that a qualied electrician perform all wiring.
This xture must be wired in accordance with all national and local
electrical codes.
This xture is designed for use in a 110-120VAC, 60Hz fused circuit.
Do not use on a dimming circuit.
This xture is intended to be used for general outdoor lighting in wet
locations.
-40°C minimum operating temperature.
WARNING: Do not handle any energized xture or attempt to
energize any xture with wet hands or while standing on a wet or
damp surface or in water.
WARNING: To reduce the risk of electrical shock, and to assure
proper operation, this xture must be adequately grounded. To
accomplish proper grounding, there must be a separate ground wire
(green) contact between this xture and the ground connection of
your main power supply panel.
WARNING: There is no serviceable part inside the photo sensor.
DO NOT try to repair or disassemble the unit. Doing so could damage
the unit or result in electrical shock. Consult a qualied electrician
if needed.
DISCLAIMER
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules and Canadian ICES-003. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
□ Reorient or relocate the receiver antenna.
□ Increase the separation between the equipment and receiver.
□ Install the product onto on a circuit different from that to which the receiver is connected.
□ Consult with the dealer or an experienced radio/TV technician for help.
□ Any modications to this xture may void the warranty and interfere with the safe operation of the luminaire.
LIMITED FACTORY WARRANTY
The manufacturer warrants this xture to be free from defects in materials and workmanship when installed and used under normal
operating conditions for a period of 3 years from the date of purchase. This warranty covers all component parts and extends only to the
replacement of a defective xture or components; it does not cover failure due to improper installation, misuse, mishandling, or damage
incurred in transit.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.HAMPTONBAY.com.
Warranty
Safety Information