SDS
Page 4/8
Material Safety Data Sheet
Printing date 02/13/2012 Reviewed on 02/03/2012
Trade name: Ni-MH BATTERY
(Contd. of page 3)
34.0.6
1310-73-2 sodium hydroxide
PEL (USA)
REL (USA)
TLV (USA)
WEL (Great Britain)
2 mg/m³
Short-term value: C 2 mg/m³
Short-term value: C 2 mg/m³
Short-term value: 2 mg/m³
7439-96-5 manganese
PEL (USA)
REL (USA)
TLV (USA)
Short-term value: C 5* ** mg/m³
as Mn *and inorganic compounds **fume
Short-term value: 3* ** mg/m³
Long-term value: 1* ** mg/m³
as Mn *and inorganic compounds **fume
(0.2) NIC-0.02* NIC-0.2* mg/m³
as Mn;+ inorg. comp.;*resp.,**inh. fraction:NIC-A4
1310-58-3 potassium hydroxide
REL (USA)
TLV (USA)
WEL (Great Britain)
C2 mg/m³
Short-term value: C 2 mg/m³
Short-term value: 2 mg/m³
·
Additional information:
The lists that were valid during the creation were used as basis.
·
Personal protective equipment:
·
General protective and hygienic measures:
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Store protective clothing separately.
Avoid contact with the eyes and skin.
·
Breathing equipment:
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure
use respiratory protective device that is independent of circulating air.
·
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
·
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be
observed.
·
Eye protection:
Tightly sealed goggles
USA
(Contd. on page 5)