Instructions / Assembly

28 | Installation How-Tos Installation How-Tos | 29
Wall Filler; Base, Wall (continued)
Place, shim, level, and install the nal cabinet. With the nal
cabinet in place, measure the gap between the wall and the top
of the cabinet.
If the wall contour is even, use this dimension to mark and cut
the Filler.
If the wall contour is irregular, you’ll need to scribe the surface
of the Filler.
Clamp the Filler to the adjacent cabinet so the edges are exactly
aligned. Set a protractor compass to the exact width of the ller.
Before scribing, put masking tape down the Filler where the
scribe mark will be. This tape will show the mark better and will
protect the Wall Filler surface when cutting.
Use the protractor compass to scribe the wall contour onto the
Wall Filler.
Cut the Wall Filler, following the scribe mark. Put the Filler in
position. Fasten the Filler to the cabinet frame using the Frame-
to-Frame Attachment requirements. Use nishing nails to tack
the Wall Filler to the Backer Board, if necessary.
Fillers for Various Depth
When installing cabinets next to each other that are different depths
(i.e. 12" deep next to 24" deep), a Filler or Full Height Panel will be
required to maintain the spacing of the cabinets.
If a Filler is used, cut the Filler equal to the height of the Wall or Base
cabinet Face Frame. The Filler width should match the space from
the cabinet side to the edge of the Face Frame.
Before positioning the cabinets, attach the Filler to the Face Frame
edge of the cabinet already in place using the Frame-to-Frame
Attachment requirements.
Transfer
Width to Filler
Masking Tape
Filler Width
Transfer Wall Contour
to Filler Wall Strip
Compass
Backer Board