Item #704696 Model #S5-BDL00320 USE AND CARE GUIDE BLAIRSVILLE 5PC FIREPIT CHAT SET - FIREPIT Questions, problems, missing parts? Before returning to the store, call Hampton Bay Customer Service 8 a.m. - 7 p.m., EST, Monday - Friday, 9 a.m. - 6 p.m., EST, Saturday 1-855-HD-HAMPTON HAMPTONBAY.COM CSA Model 99010 THANK YOU quality products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs.
Table of Contents Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Save These Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Important Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . 2 Important Safety Information - Propane (LP) Gas . . . . . . . . . 3 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 2-Year Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . .
Safety Information (continued) IMPORTANT SAFETY INFORMATION - CAUTION: The propane gas pressure regulator provided with this appliance must be used. This regulator is set for an outlet pressure of 11 in. water column. A self-contained LP gas cylinder for use with this appliance must have a capacity of 20 lbs. and must be equipped with a Type 1 CAUTION: This outdoor gas appliance is not intended to be installed in or on recreational vehicles and/or boats.
Warranty 3 YEAR TOP / 2 YEAR FRAME / 2 YEAR BURNER ASSEMBLY LIMITED WARRANTY WHAT IS COVERED The item you have purchased is warranted against defects in materials and workmanship for the following parts as outlined below only when the unit is installed and operated in accordance with the instructions in this Owner’s Manual and in compliance with local building � Burner Assembly � Firepit Base � Firepit Top HOW DO I OBTAIN WARRANTY SERVICE? To obtain warranty service, you must contact our customer service c
Pre-Assembly PLANNING ASSEMBLY part appears missing or damaged, do not assemble or use this product. Contact the Customer Service Team at 1-855-HD-HAMPTON. SPECIFICATIONS Input 40,000 BTU/hr Propane Regulator Pressure 11 in. water column Clearances to Combustible Surfaces Sides: 24 in./61 cm Top: 72 in./183 cm HARDWARE INCLUDED NOTE: Hardware shown to actual size. AA BB CC DD Part Description Part # Quantity AA ¼ in. x 15 mm bolt HW0034 10 BB ¼ in.
Pre-Assembly (continued) PACKAGE CONTENTS L A D J O M B C E N F Q G H K I P Part A Description Part # Quantity Part Control knob* FP1245 1 K Description Part # Quantity Footcap FC0508 4 B Gas valve* FP0307 1 L Table Rim With lp Support FP1427 1 C Thermocouple* FP0004 1 M Back panel FP1428 1 D LP Regulator hose FP1329 1 N Left side panel FP1429 1 E Electrode* FP1330 1 O Right side panel FP1430 1 FP0310 1 P Door panel FP1431 1 Ignition module* FP0006
Assembly 1 2 Assembling the side panels � Attach the back panel (M) to the left and right side panels (N and O) using four ¼ in. x 45 mm bolts (BB) and Ø6.5 X 1.0 mm washers (EE). Guide the bolts (BB) through the holes in the back panel (M) and into the pre-drilled holes in the side panels (N and O). Hand tighten only. Attaching the middle support � Attach the middle support (Q) to the side panels (N and O) using two ¼ in. x 15 mm bolts (AA) and Ø6.5 X 1.0 mm washers (EE).
Assembly (continued) 5 Connecting the gas tank � Place a gas tank (not included) onto the middle support (Q) and connect the regulator hose (D) to the tank. Screw the black handle clockwise to tighten. Turn the handle counterclockwise to remove. The hose must point down. Check that the valve is turned all the way clockwise to the "OFF" position.
Assembly (continued) 9 10 Testing for leaks Installing the battery � Make sure the control knob is in the "OFF" position. Unscrew the push button cap on the ignition module located on the control panel to access the battery compartment. The ignition module requires one Alkaline � Open the tank valve. Apply a solution of soapy water to the tank-regulator connection and to the valve-hose connection to check for leaks. If soap bubbles continue to form, the connection has a leak.
Lighting a Fire WARNING: If these instructions are not followed exactly, personal injury or loss of life. 1. Make sure the control knob is in the “OFF” position. Open the tank valve all the way. 2. Push in the igniter button. You will hear a slight clicking sound. With the igniter button pushed in, push and turn the IGNITOR PATIO GLOW OFF PATENT PENDING and continue to hold the control knob in for 10 to 15 seconds. Release the control knob. The control knob should pop back ( 1.
Troubleshooting Problem Probable Cause The burner does not light. There is no propane gas at the burner. Check that the gas tank valve is open. Turn the control knob to the “ON” position and push the control knob in. Make sure the tank has propane gas. Solution There is no spark at the electrode. Check that the AAA battery is installed with the that the wire is connected to the ignition module. Check that the electrode is not cracked or broken.
Questions, problems, missing parts? Before returning to the store, call Hampton Bay Customer Service 8 a.m. - 7 p.m., EST, Monday - Friday, 9 a.m. - 6 p.m., EST, Saturday 1-855-HD-HAMPTON HAMPTONBAY.COM Retain this manual for future use.
