Instructions / Assembly

Assembly

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Attaching the leg connector bracket

Tightening the nuts to the bolts

□ Use the hex bolt driver (HH) and hex wrench (GG) to tighten

all nuts (DD) and bolts (AA).

□ Repeat until all bolts (AA) are tight. (Do not over tighten.

Over tightening may strip bolts.)

□ Cover all nuts (DD) and bolts (AA) with covers (EE and FF).

Attaching the table legs

□ Place the tabletop (A) up-side down on a flat, solid surface.

□ Attach a table leg (C) to the tabletop (A) using the bolts (AA)

and washers (BB) as shown in the diagram.

□ Guide the bolts (AA) through the holes in the table leg into

the pre-drilled holes in the tabletop (A).

□ Hand tighten three to four turns only. (Do not tighten

completely).

□ Repeat for the other three legs.

□ Attach a leg (C) to the leg connector bracket (B) by carefully

guiding the bolts (AA)

already in place on the table leg

(C)

through the holes in the leg connector bracket (B).

□ Add a washer (CC) and a nut (DD) to the end of each bolt.

□ Hand tighten three to four turns only. (Do not tighten

completely.)

□ Repeat for the other three legs.

JJ (Preassembled)