Use and Care Manual

7 HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Installation (continued)

Mounting the Transformer

Mounting the Photocell

To mount directly to a wall surface use the included screws (AA) as

shown, suitable for mounting within 12 in. to 48 in. (0.3 m to 1.2 m)

of the ground. When installing the screws, the spacing between the

screw centers is 3.23 in. (82 mm). See the template (D) for correct

spacing. Hang the transformer (A) onto the screws (AA).

Mount the photocell (B) bracket on a wall or other solid surface with

the screws (BB) provided. Snap the sensor into the bracket. Route or

coil the excess wire to protect it from lawn mowers, trimmers, etc.

Avoid pointing the sensor at nighttime light sources such as

windows, porch lights, and street lights.

Placing the sensor in areas receiving less sunlight at dusk (east side

of house, behind trees and bushes, under a deck) will have the

transformer come on earlier in the evening. Mounting the photocell in

brighter locations will have the transformer come on when it has

become darker out. The location, position and orientation of the

photocell can be adjusted until the transformer turns on at the

desired light level.

If the wires to the photocell are cut or broken, the photocell can

be replaced. Unscrew the photocell connector cover from the

transformer and pull the bi-pin connector out of the mating socket.

The replacement part is inserted into the socket and the cap is

screwed back onto the socket to provide a water tight connection.

Note that the bi-pin connector is polarized and can be inserted into

the socket only one way. The photo eye operation can be tested by

turning the transformer mode to TEST.

Replacement photocell is available in the store.

Cover the connection hole with the dust cap when no photocell

control wire is connected.

Once all fixtures are in place and you are satisfied with their

locations, the cable may be covered with mulch or buried up to

6 in. (15 cm) deep. Leave about 12 in. (30 cm) of cable after the

last fixture.

Protecting or Hiding the Cable

WARNING: Risk of Fire

DO not coil cable around transformer. Total bulb

wattages must not exceed a maximum of 45 watts.