KITCHEN CABINET Installation Guide
. Find the high spot in the floor using a level as shown below. • Layout and Planning the Installation 1. Take of the cabinets as per the plan or order. • Layout and Planning theinventory Installation The instructions given here serve as a general guideline on how to install frameless cabinets in The instructions given here serve as a general guideline on how to install frameless cabinets in a a reasonably simple installation.
5. It is best when installing a larger kitchen to mark the positions and code (size) on the wall. Better to • cabinet Cabinet Installation Order 5. It is best when installing a larger kitchen to now markif the cabinet (size) on the wall. Betterseveral toorder cabinets. find out things aren’t positions going to fitand justcode right1.than after you’ve installed Determining the installation of the cabinets depends on the plan. As a general rule it is better to 6.
• • Correcting for a “Bowed In” or “Bellied” Wall Condition Correcting for a “Bowed In” or “Bellied” Wall Condition W3036 CORRECTING FOR A “BOWEDW3036 IN” OR “BELLIED” WALL CONDITION W3036 W3036 Boxes are at an angle toBoxes each other W3036 are at an angle to each other W3036 Boxes are at an angle toBoxes each other areare atatan Boxes an angle angle for In” a “Bowed In” orWall “Bellied” Wall Condition CorrectingCorrecting for a “Bowed or “Bellied” Condition W3036 W3036 W3036 W3036 W3036 notBox alig
INSTALLING TRIM • LIGHT RAIL Installing Trim 1. I nstalling crown molding can be accomplished in a variety of ways depending on the application. Using “frame1. Installing crownmeans molding be accomplished in aalways varietyhave of ways Using less cabinets” thatcan a sub-crown molding will to be depending screwed to on thethe topapplication. of the cabinet case to “frameless cabinets” means that a sub-crown molding will always have to be screwed to the top of the attach the crown molding to.
ut of Alignment Condition Alignment Condition Corrected ' In and Out Adjustment ' ADJUSTING DOORS AND DRAWERS (continued) DRAWER ADJUSTMENT DOORS AND DRAWERS Hinge Removal and Reinstallation Standard Drawer M ounting Plate H inge Release Plunger To Rem ove a M ounted H inge: Push the Release Plunger in from the Back of the H inge The H inge W ill D isengage from the M ounting Plate To Rem ount a H inge: Push the Back of the H inge into the Plate Until it Clicks Align and Insert the H inge Hook
Limited Lifetime Warranty ___________________________________________ RSI Home Products, Inc. is a subsidiary of American Woodmark Corporation. This warranty covers substantial defects in materials and workmanship in your Hampton Bay Designers Series products under normal home use. This warranty is offered only to the original consumer purchaser and may not be transferred.
