Installation Guide

9 HAMPTONBAY.COM

Please contact 1-877-527-03123 for further assistance.

Installation (continued)

Balancing the blades

All blades are grouped by weight. Because natural woods vary in

density, the fan may wobble even though the blades are weight

matched.

The following procedure should correct most fan wobble. Check for

wobble after each step.

□ Check that all blade and blade holder screws are secure.

□ Most fan wobble problems are caused when blade levels

are unequal. Check this level by selecting a point on the

ceiling above the tip of one of the blades. Measure this

distance as shown in Figure 14. Rotate the fan until the

next blade is positioned for measurement. Repeat for each

blade. Measurements should be within 1/8 in.

□ If blade wobble is still noticeable, interchanging two

adjacent (side by side) blades can redistribute the weight

and possibly result in smoother operation.

Figure 14

Touch Ceiling

Installing the light kit

WARNING: To reduce the risk of electric shock,

disconnect the electrical supply circuit to the fan before

installing light kit.

CAUTION: Do not use pliers or screwdrivers to tighten

the thumb screws. Overtightening of the thumb screws may

crack the lamp shades

□ Install a light bulb (max. 60W, medium screw base) to the

lampholder (Figure 15).

□ Install the lamp shade into the lamp-tter by tightening the

thumb screws (Figure 16).

Figure 15

Light Bulb

Lamp Holder

Figure 16

THD_HamptonBay_UE42V-SHB_HD195.indd 9 12年11月21日下午11:34