Instructions / Assembly

18
Installation
o The Toekick Platform is shipped unattached on 96” Tall cabinets. If
the ceiling height is enough so the 96” high Tall cabinet can be
tipped up with the Toekick Platform installed, then you should install
the Toekick Platform before attaching the cabinet to the wall.
o The Platform is narrower than the cabinet and can be mounted at
the center, right, or left. This provides for Toekick space on the
sides when the cabinets are end-mounted. Lay the cabinet on its
back. Position the Toekick Platform to the back of the cabinet and to
the left, right, or center of the cabinet width.
o Drill pilot holes through the corner gussets and into the wood cleats
in the bottom of the cabinet. Fasten the platform to the bottom of the
cabinet with the appropriate length wood screws (not provided).
o Set the cabinet upright and install according to the Attachment to
Wall requirements for Tall cabinets.
o If the ceiling height does not permit installing the Toekick Platform
to the cabinet before installation, then install and level the Toekick
Platform first.
o Position the Toekick Platform on the floor. Shim and level following
the same procedure for installing a Base Cabinet. The top of the
Toekick Platform should match the height of the bottom edge of
the Base cabinet Face Frame. Mark wall stud locations and predrill
according to the Attachment to Wall requirements for Tall cabinets.
o Carefully lift and slide the cabinet onto the Toekick Platform. Attach
to the wall following the Attachment to Wall requirements for Tall
cabinets.
17
TOEKICK PLATFORM WITH 96" TALL CABINETS
o The Tall End Filler conceals the side of a refrigerator and supports
a 24" Deep Wall Cabinet above. Tall End Fillers are shipped without a
Toespace Cutout and must be inverted for left- or right- hand use
before marking and cutting the Toespace.
o Determine whether the application is Left- or Right- Hand. Measure
the Toekick height and depth from an adjacent Base Cabinet and
transfer these dimensions to the proper end of the Tall End Filler.
Follow dimensions to cut out the Toespace.
o Put Tall End Filler in place. Align the top of the Tall End Filler either to
the Wall Cabinet Top Level Line or to the top of an adjacent Wall
Cabinet.
o If needed, shim the Tall End Filler so the Face Frame is plumb
and lined up with the bottom of the Base Cabinet. Attach the Filler
to the adjacent cabinet according to the Frame-to-Frame Attachment
requirements.
o Use angle brackets or Backer Board (not provided) to attach the back
edge of the Tall End Filler to the wall and floor. If needed, install Filler
between a Wall Cabinet and the Tall End Filler. After one Tall End
Filler is installed, install the 24" Deep Wall Cabinet according to the
Deep Wall Cabinet requirements.
o Install the Tall End Filler for the opposite side, if applicable.
16
TALL END FILLER & 24" DEEP WALL CABINET
INSTALLATION
ToekickBase
PositionedRight
ToekickBase
PositionedCennter
ToekickBase
PositionedLeft
Tall Cabinet Face Frame
Wood Cleats
Toekick Platform
Corner Gussets