Use and Care Manual

1. Make sure rotary switches are in the OFF position.

2. Plug into 120V AC electric outlet.

3. Set the individual fan motors on either In ( intake ), Out ( exhaust ) or Exch

(exchange) using the control lever.

4. Turn the Thermostat Control to its highest setting (full clockwise).

5. To start the unit turn the rotary switches to desired speed: 0=Off, 3=High,

2=Medium, 1=Low.

6. While the window fan is on, turn the Thermostat Control counter-clockwise towards

the smaller dots until the fan stops (Away from Cooler). This is the selected comfort

level.

7. If the fan is stopped and you want to turn it back on, turn the Thermostat Control

clockwise until the fan starts, towards the larger dots (Towards Cooler).

Care And Maintenance

TO CLEAN: Always disconnect the power cord from the electrical outlet when

cleaning your fan. Light accumulated dust can be removed by using a soft cloth to wipe

away the dust at the back grille of the fan. Wipe the exterior surfaces of the fan

occasionally with a damp cloth (not dripping wet) and dry thoroughly with a soft dry cloth

before operating the fan. Do not use harsh cleaners or materials to clean this unit, doing

so will cause damages to it

CAUTION: DO NOT ALLOW WATER TO RUN INTO THE INTERIOR OF THE FAN AS THIS

COULD CREATE A FIRE OR ELECTRIC SHOCK HAZARD. THE FAN MOTOR IS FACTORY

LUBRICATED FOR LIFE AND WILL REQUIRE NO FURTHER LUBRICATION NO OTHER USER

MAINTENANCE IS REQUIRED OR RECOMMENDED. IF SERVICE IS REQUIRED, SEND YOUR

FAN TO THE AUTHORIZED SERVICE FACILITY.

TO STORE: Make sure to disassemble and clean the fan before storing. Retain the

original packaging for the purpose of storing your fan. Always store fan in a dry place.

Never store it while it is still plugged in. Never wrap the cord tightly around the fan, and

do not put any stress on the cord where it enters the fan, as it could cause the cord to fray

and break.

Operating Instructions