Instructions / Assembly

Installing the Light Kit
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
While holding the light plate under your fan,
locate two single white and blue wires in the
switch housing labeled FOR LIGHT. Make the
polarized plug connections:
- White to white
- Blue to black
Carefully push all wires back into the switch
housing, then install the light plate onto the
switch housing with 3 screws provided. Be
sure to tighten all screws.
(Fig. 12)
Install 2 x 9.5W LED bulbs (included). (Fig.
12)
Raise glass shade up against the light kit and
secure it to fan by turning glass clockwise until
snug. DO NOT OVERTIGHTEN. (Fig. 12)
Restore power and your light kit is ready for
operation.
1.
2.
3.
4.
5.
CAUTION
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
Figure 12
Screws
Glass
Shade
Bulbs
Wire Connectors
Switch Housing
Light Plate
9