Instructions / Assembly

B
MM
E
OO
NN
7
Assembly — Installing the Light Kit
8
Attaching the switch housing
to the mounting ring
□ Remove one of the three switch housing mounting
screws (MM) from the mounting ring (NN) and loosen
the other two screws (MM). (Do not remove)
□ While holding the switch housing (E) under the fan
motor assembly (B), snap together the wire
connection plugs (OO).
□ Place the key holes in the switch housing (E) over the
two screws (MM) previously loosened from the
mounting ring (NN). Turn the switch housing (E) until
the switch housing (E) locks in place at the narrow
section of the key holes.
□ Securely tighten the two mounting plate screws (MM)
previously loosened and the one (MM) previously
removed.
CAUTION: Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufcient to prevent electric shock.
Attaching the light kit to
the switch housing
□ Remove one of the three light kit mounting screws (PP)
from the switch housing (E), and loosen the other two
screws (PP). (Do not remove)
□ While holding the light kit (F) under your fan motor
assembly (B), locate two single white and blue wires in
the switch housing labeled "FOR LIGHT". Make the
polarized plug connections (QQ):
- White to white
- Blue to black
□ Carefully push all wires back into the switch housing (E).
Place the key holes on the light kit (F) over the two light
kit mounting screws (PP) previously loosened from the
switch housing (E). Turn the light kit (F) until the light kit
(F) locks in place at the narrow section of the key holes.
□ Securely tighten the two light kit mounting screws (PP)
previously loosened and the one (PP) previously removed.
B
F
PP
QQ
E
13 HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.