Installation Guide

10
Installing the Light kit
CAUTION
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
NOTE
FOR NON-LIGHT USE PURPOSE, THE SWITCH
HOUSING COVER IS AVAILABLE BY CALLING
THE TOLL FREE NUMBER 1-877-898-1881.
Bulbs
Thumb Screws
Glass Shades
Figure 16
Screws
Light kit
Reverse
Switch
Wire Connector
Switch
Housing
Figure 15
While holding the light kit under your fan,
locate two single white and blue wires in the
switch housing labeled "FOR LIGHT". Make
the polarized plug connections:
- White to white
- Blue to black
Carefully push all wires back into the switch
housing. Attach the light kit fitter by aligning its
keyhole slots with the three screw holes and the
reverse switch on the side of the switch housing.
Tighten the three screws securely to prevent the
light kit from vibrating loose. (Fig. 15)
Mount the glass shades to the light fixture by
unscrewing partway the thumbscrews on the
glass holders, insert the glass, then gently
tighten the thumbscrews by hand evenly to the
glass. DO NOT OVER TIGHTEN (Fig. 16).
Install three 13 Watt compact fluorescent bulbs
(included). NOTE: CFL bulbs are NOT
dimmable.
1.
2.
3.
4.