Instructions / Assembly

Assembly — Hanging the Fan (continued)

Preparing the receiver and

remote control

If you feel you do not have enough electrical wiring

knowledge or experience, have your fan installed by a

licensed electrician.

This remote control unit is equipped with 16 code

combinations to prevent possible interference from or to

other remote units. The frequency switches on your

receiver (EE) and remote control (FF) have been preset at

the factory. Please recheck to make sure the switches on

the remote control (FF) and the receiver (EE) are set to the

same position. Any combination of settings will operate

the fan as long as the switches in the remote control (FF)

and receiver (EE) are set to the same position.

□ After checking the switches, insert the receiver (EE)

into the mounting bracket (A) with the ﬂat side of the

receiver (EE) facing the ceiling.

CAUTION: Do not use with a wall light dimmer switch.

WARNING: To avoid possible electrical shock, be sure

electricity is turned off at the main fuse box before wiring.