Instructions / Assembly

JJJ

Attaching the light kit mounting

plate to the mounting ring

□ Remove one of the three light kit mounting plate

screws (NN) from the mounting ring (JJJ) and loosen

the other two screws. (Do not remove.)

□ Place the key holes in the light kit mounting plate (I)

over the two screws (NN) previously loosened from

the mounting ring (JJJ). Turn the light kit mounting

plate (I) until the light kit mounting plate (I) locks in

place at the narrow section of the key holes. Secure

by tightening the two mounting plate screws (NN)

previously loosened and the one (NN) previously

removed.

Attaching the LED light kit to

the light kit mounting plate

□ Remove one of the three light kit mounting screws

(OO) from the light kit mounting plate (I) and loosen

the other two screws (OO). (Do not remove.)

□ While holding the LED light kit (J) under the fan motor

assembly (F), make the 2-pin wire connections:

- Red to white

- Black to black

□ Place the key holes in the LED light kit (J) over the

two mounting screws (OO) previously loosened from

the light kit mounting plate (I). Turn the LED light kit

(J) until the LED light kit (J) locks in place at the

narrow section of the key holes. Secure by tightening

the two light kit mounting screws (OO) previously

loosened and the one (OO) previously removed.

Assembly — Installing the Light Kit

CAUTION: Before starting installation, disconnect the

power by turning off the circuit breaker or removing the fuse

at the fuse box. Turning power off using the fan switch is not

sufﬁcient to prevent electric shock.