Installation Guide

18
Operation
1
Attaching the crank
Attach the crank (F) to the handle as shown in figure (1).
Attach the crank (F) by aligning the tap with the hole on the crank (F) until it snaps into place.
To detach the crank, the hex wrench (DD) is required to press the tap to take the crank (F) out.
Attach the crank (F) without using the tap as shown in figure (2).
To detach the crank (F), just take the crank out.
NOTE: Both methods of attaching the crank (F)
are acceptable.
EE
F
2
1
F
2
1
(1)
(2)